Alternator Failure

	ALT 1 Light Steady
	ALT 1 Master Switch	Off
	Alternator 1 Circuit Breaker	Check and Reset
	ALT 1 Master Switch	On
	If Alternator Does Not Reset
	Switch of unnecessary equipment on Main Bus 1, Main Bus 2, and the non-essential Buses to reduce loads. Monitor voltage
	ALT 1 Master Switch	Off
	Land	ASAP

	ALT 1 Light Flashing
	Ammeter Switch	Batt
	If Charging rate is greater than 30 amps, reduce load on Main Bus1, Main Bus 2, and Non-Essential Buses.
	Monitor Ammeter until battery charge is less than 15 Amps
	When battery charge rate is within limits, add loads as necessary for flight conditions

	ALT 2 Light Steady
	ALT 2 Master Switch	Off
	Alternator 2 Circuit Breaker	Check and Reset
	ALT 2 Master Switch	On
	If Alternator Does Not Reset
	Switch of unnecessary equipment on Main Bus 1, Main Bus 2, and the non-essential Buses to reduce loads.
	ALT 2 Master Switch	Off
	Land	ASAP